Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
scenario-modem [2015/05/04 14:03]
nworbnhoj [Approach] add network segment explanation
scenario-modem [2015/05/04 14:05] (current)
nworbnhoj [Reconfigure existing Modem/Router] simplify
Line 31: Line 31:
 If you are configuring an __ADSL__ modem then it is preferable (if possible) to put the modem in**to bridge** mode; which in effect, will connect Gargoyle directly to your ISP. If you are configuring an __ADSL__ modem then it is preferable (if possible) to put the modem in**to bridge** mode; which in effect, will connect Gargoyle directly to your ISP.
  
-Otherwise, if you can**not bridge**, then set the Modem LAN IP Address to **192.168.0.1** to form one node on a very simple network segment just between the Modem and the Gargoyle router (see below). ​Another network segment will connect all of your devices with IP addresses like 192.168.1.XXX+Otherwise, if you can**not bridge**, then set the Modem LAN IP Address to **192.168.0.1** to form one node on a very simple network segment just between the Modem and the Gargoyle router (see below).
  
  
scenario-modem.txt ยท Last modified: 2015/05/04 14:05 by nworbnhoj
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki