Hello!
My father addressed a problem: a router is connected in the house, connected via optics and distributing only WiFi, how to connect the WR-1043ND as a repeater, provided that there is no UTP-5e cable ?! Advise what to purchase for such a connection, if necessary.
WR-1043ND repiter WiFi
Moderator: Moderators
Re: WR-1043ND repiter WiFi
No cable is required to operate the Gargoyle router as a repeater, everything is done using the WiFi part. Only use the cable to set up, then it will no longer be needed. Everything is set via GUI: https://www.gargoyle-router.com/wiki/do ... e_repeater
Turris Omnia with OpenWrt 21.02 - Tested
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0
http://gargoyle.romanhk.cz custom builds by gargoyle users
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0
http://gargoyle.romanhk.cz custom builds by gargoyle users
Re: WR-1043ND repiter WiFi
Ok, will the router be able to distribute WiFi after such a setup ?!
Re: WR-1043ND repiter WiFi
Yes, when set up as a repeater, the router acts as both a client and an AP.
Attention! if the connection between the AP (master) and the client (Gargoyle) is lost, then the Gargoyle AP (slave) stops transmitting - this behavior is correct from the repeater point of view and is not an error.
Attention! if the connection between the AP (master) and the client (Gargoyle) is lost, then the Gargoyle AP (slave) stops transmitting - this behavior is correct from the repeater point of view and is not an error.Turris Omnia with OpenWrt 21.02 - Tested
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0
http://gargoyle.romanhk.cz custom builds by gargoyle users
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0
http://gargoyle.romanhk.cz custom builds by gargoyle users
Re: WR-1043ND repiter WiFi
Thank you very much!!! 