Archer C7 to original firmware

Report problems and success stories with Gargoyle on various hardware platforms.

Moderator: Moderators

Post Reply
Phil
Posts: 35
Joined: Sat Jul 20, 2013 8:09 am

Archer C7 to original firmware

Post by Phil »

As the title of the post suggest, can just use the online tp-link firmware to go from gargoyle to tp-link strait up? Or I have to use this "dd if=orig.bin of=tplink.bin skip=257 bs=512" to cut it?

techasist
Posts: 15
Joined: Wed Feb 25, 2015 9:43 pm

Re: Archer C7 to original firmware

Post by techasist »

Hi Phil,

Sorry for hijacking your thread as I don't know the answer to your question, but I'm about to purchase a Archer C5 or C7 tomorrow and would like some feedback about this router running Gargoyle 1.7.1.

I currently have a WD MyNet N600 that I bought for $5- and it's great with Gargoyle. I use it in AP+Client mode exclusively and I was wondering if the 2.4GHz receiver sensitivity was good on the Archer.

Thanks.
WD MyNet N600 - Gargoyle 1.7.1
TP-Link Archer C5 - OpenWrt (community release)

techasist
Posts: 15
Joined: Wed Feb 25, 2015 9:43 pm

Re: Archer C7 to original firmware

Post by techasist »

Same problem here. I purchased and flashed my Archer C5 today with v1.7.1 (no 5GHz) and with v1.7.x (no 5GHz). Now on v1.7.x I can't do update firmware or reset to default config.

Any help?
WD MyNet N600 - Gargoyle 1.7.1
TP-Link Archer C5 - OpenWrt (community release)

techasist
Posts: 15
Joined: Wed Feb 25, 2015 9:43 pm

Re: Archer C7 to original firmware

Post by techasist »

Finally was able to go back to v1.7.1. I had to copy sys upgrade.bin by SCP to /tmp and from there upgraded to v1.7.1.

Once in v1.7.1 I can flash other firmwares (OpenWrt, Tp-Link) as usual :D
WD MyNet N600 - Gargoyle 1.7.1
TP-Link Archer C5 - OpenWrt (community release)

Post Reply