Gargoyle Forum

Hi, Since installing 1.5.11 on my WDR4300 in the hope that it may help with my wireless woes I have a new problem. If I save changes to my wireless config (eg power level) from the connection form the router does something that causes both wired and wireless clients to lose the Internet. I am using ...

UPDATE :-( The wireless performance was good for a day or two - everyone could connect and range was acceptable. Unfortunately it has gone awry again with Android devices devices reporting 'Authentication Error' when attempting to connect with correct credentials. Devices that do connect have poor r...

Hi All, I found the problem with my router. Recall that it is a WDR4300 bridged to a Thomson TG587. I observed the WDR4300 to boot then reset after a few minutes. I tried: removing the WAN cable turning off wireless Then I guessed that the NVRAM may have been trashed. so I put the modem into recover...

Hi BashfulBladder,

Thanks for your suggestions.

I will try updating to v1.5.11 (wasn't aware of the update) and lowering the power level. I located quiet channel space using WIFI Analyser on my Android phone.

I'll let you know how I get on.

Thanks again.

Hi, I have noticed the same issue. I use the TP-LINK WDR4300 with Gargoyle 1.5.10. I bought the router specifically for it's quota management feature and installed Gargoyle on day one. After fighting with the Thomson TG587 to put it into bridge mode AND make sure it had its wireless turned off, UPNP...

Hi,

It was IE9. I downloaded Chrome and it worked fine.

Now I need to figure out how to make Gargoyle play nicely with my grotty Technolour/Thomson TG587 ADSL router modem. Any info on this anwhere?

Thanks,

Andrew.

Hi, I purchased a new TP-LINK WDR4300 because it seemed like the most well endowed router for a reasonable price and because it is supported by Gargoyle. I plan to set up quotas so that my children cannot gobble up all of our monthly Internet allocation :-) Flashed successfully by shortening filenam...