wireless N on v1.8.1

[MucuCat]

i have wr841n v8 router. on every build of 1.9 ACC does not work for me so i reverted back to v1.8.1. On this build ACC does work (while saturated ping without ACC around 150, with ACC bellow 80ms) but i cant disble wireless N mode. i would like to have it enabled and it works fine in the same room as the router is, but in my bedroom it disconnects a lot which is annoying while playing hearthstone :p

is there any way to disable wireless N mode? Or is there a ispy build of 1.8.1 that i can try?

Actually while writing this i was downloading at full speed and measuring ping. i got few timeouts and after 5min i lost connection with router. idk if its because of the wireless N or the router itself (i am 3m away from the router).

Also i have a nother question. while downloading a torrent i get less than 80ms ping. if i limit the torrent itself to lets say 50% of my bandwidth i get 12ms ping. But if i set 50% of my bandwidt on gargoyle for my pc and i start to download, the torrent will use the max 50% of bandwidth, but the ping will be 120ms or higher. How come?

[Lantis]

i have wr841n v8 router. on every build of 1.9 ACC does not work for me so i reverted back to v1.8.1. On this build ACC does work (while saturated ping without ACC around 150, with ACC bellow 80ms) but i cant disble wireless N mode. i would like to have it enabled and it works fine in the same room as the router is, but in my bedroom it disconnects a lot which is annoying while playing hearthstone :p

is there any way to disable wireless N mode? Or is there a ispy build of 1.8.1 that i can try?

You can disable it by editing the wireless config and setting the HTMODE to NONE.

Also i have a nother question. while downloading a torrent i get less than 80ms ping. if i limit the torrent itself to lets say 50% of my bandwidth i get 12ms ping. But if i set 50% of my bandwidt on gargoyle for my pc and i start to download, the torrent will use the max 50% of bandwidth, but the ping will be 120ms or higher. How come?

If your link is approaching saturation the ACK requests will get delayed and your ping will increase.

[tapper]

set your 2.4GHz Channel Width: to 20 MHZ. If that dont work then set your 2.4GHz Operation Mode: B+G

[MucuCat]

on 1.8.1 you cant set B+G (only B+G+N). but i did set it to 20mhz and it did work. wireless isnt dropping anymore. thank you