Netgear WNR1000v2 support?

[jenom]

Netgear's WNR1000v2 now is fully supported in OpenWrt Chaos_Calmer 15.05
Will it be supported in Gargoyle 1.9.0 when it becomes available ?
Thanks!

[ispyisail]

only 4 meg of flash

That is a problem going forward

[jenom]

I can see a Gargoyle firmware on the download section for a similar AR7xx WNR2000, also with 4 MB memory.
Web-Gui LUCI loads pages a bit slow to my taste in Calmer-Chaos, however it seems very responsive in Barrier-Breaker.
My experience with Gargoyle GUI is that it was always worked faster then Open-Wrt's LUCI.
So it would nice to have a Gragoyle for WNR1000 either with BB or CC

[t333to]

WNR1000v2 has exactly the same hardware as WNR612v2, the only difference is the number of LAN ports. So if WNR1000v2 is supported the WNR612v2 should be to.

https://wikidevi.com/wiki/Netgear_WNR612v2

There is also a rebranded WNR612v2, the "On Networks N150":
https://wiki.openwrt.org/toh/netgear/wnr612v2

[jenom]

Managed to put with tftp Open Wrt Barrier Breaker 14.07 with LuCI 0.12
Running without any issues!