WDS on MR3201A 1-port atheros unreliable / losing config?

[Chilling_Silence]

Hi all,

I've been putting Gargoyle on some of the Open-mesh OM1P / MR3201A routers.

Tested with 1.3.2 and 1.3.3, basically the setup of the main Gateway AP works fine, but when you configure the others as WDS client nodes, then you go back to the WebGUI, they appear to have lost their config for that part. The IP Address aves OK, and they connect initially, but when they get power cycled they don't seem to come back up again resulting in the requirement of a reflash (The joys of no "factory reset" button).

I'm just about to test with 1.2.4, however I was under the impression based on this thread that it was resolved in 1.3.1, though it's not mentioned in the changelogs:
http://www.gargoyle-router.com/phpbb/vi ... ?f=6&t=442

Does anybody else have similar results?

It doesn't seem to happen on all restarts, but it is happening :-/

[Chilling_Silence]

So I re-flashed one with 1.3.2 and it failed
I flashed one with 1.2.4 and it also failed
I flashed it then with 1.3.3 and it joined the WDS and has kept it's config.

I flashed another with 1.2.4 and it lost its config upon reboot. I re-flashed it with 1.3.3 and it's working this time.

The Gateway router is running 1.3.2 this whole time.

Odd indeed ...