TP-Link TL-WR1043N/ND v2
and
TP-Link TL-WDR4300 v1
The WAN Port from WDR4300 has been set for LAN too
and both are connected with a devolo POWER LAN.
Speed possible would be about 200 Mbit/sec from Devolo.
But the Router seems only to work on 100 Mbit/sec.
How can i force both to go for more or setting to 1000 Mbit/sec?
Client connecting to 192.168.1.1, TCP port 5001
TCP window size: 21.0 KByte (default)
------------------------------------------------------------
[ 3] local 192.168.1.2 port 44313 connected with 192.168.1.1 port 5001
[ ID] Interval Transfer Bandwidth
[ 3] 0.0-10.0 sec 51.0 MBytes 42.7 Mbits/sec
ethtool:
Settings for eth0:
Supported ports: [ ]
Supported link modes: 1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: No
Advertised link modes: 1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: No
Speed: 1000Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: external
Auto-negotiation: off
Current message level: 0x000000ff (255)
drv probe link timer ifdown ifup rx_err tx_err
Link detected: yes
TP-Link TL-WR1043N/ND v2
swconfig dev switch0 show | grep link
link: port:0 link:up speed:1000baseT full-duplex txflow rxflow
link: port:1 link:up speed:1000baseT full-duplex auto
link: port:2 link:up speed:100baseT full-duplex auto
link: port:3 link:down
link: port:4 link:down
link: port:5 link:up speed:1000baseT full-duplex auto
link: port:6 link:up speed:1000baseT full-duplex txflow rxflow
Port 2 = Devolo Power LAN (dLAN 550 duo+)
TP-Link TL-WDR4300 v1
link: port:0 link:up speed:1000baseT full-duplex txflow rxflow
link: port:1 link:up speed:100baseT full-duplex auto
link: port:2 link:up speed:100baseT full-duplex auto
link: port:3 link:up speed:100baseT full-duplex auto
link: port:4 link:down
link: port:5 link:down
link: port:6 link:down
Port 1 = Devolo Power LAN (dLAN 550 duo+)
Any help is appreciated
