Break Out of an Endless Boot TFTP instal

Report problems and success stories with Gargoyle on various hardware platforms.

Moderator: Moderators

Post Reply
NeverEnoughHours
Posts: 3
Joined: Sat Dec 06, 2014 5:18 pm

Break Out of an Endless Boot TFTP instal

Post by NeverEnoughHours »

It looks like I am stuck. Can't get into my router: TL-WR841N Ver 9.1 to stop rebooting.

After I attempted to install OpenWrt, it continues to reboot and all lights flash with each boot.

Typing tpl doesn't stop it. It gives me the error of:

## Booting image at 9f020000 ...
Uncompressing Kernel Image ... Too big uncompressed streamLZMA ERROR 1 - must RESET board to recover

Anyone have any advice to help me?

I should also say that before this problem, I was unable to get the reset button to do anything... even using the 30/30/30 reset. And this was part of the reason I was trying to intall OpenWrt to see if the reset button would start working. I've ohmed out the button and electrically it is good.

ispyisail
Moderator
Posts: 5212
Joined: Mon Apr 06, 2009 3:15 am
Location: New Zealand

Re: Break Out of an Endless Boot TFTP instal

Post by ispyisail »

first read
http://wiki.openwrt.org/toh/tp-link/tl-wr841nd

Try Failsafe reset
http://wiki.openwrt.org/doc/howto/generic.failsafe

If that doesn't work try serial cable

pbix
Developer
Posts: 1373
Joined: Fri Aug 21, 2009 5:09 pm

Re: Break Out of an Endless Boot TFTP instal

Post by pbix »

I doubt failsafe is going to work for you since OpenWRT is unable to boot.

On the page referenced by ispyisall there are directions on how to use a serial cable to interrupt the bootloader boot cycle and then load an new firmware image via TFTP. It called "TFTP Install". I think that will be your path to recovery.

Once it is recovered you might want to consider putting uboot on there so that if this ever happens again you can recover via Ethernet.
Linksys WRT1900ACv2
Netgear WNDR3700v2
TP Link 1043ND v3
TP-Link TL-WDR3600 v1
Buffalo WZR-HP-G300NH2
WRT54G-TM

Post Reply