Anyone with the same issue?
Anyone have suggestions on how to fix this behaviour?
Thank you in advance!
And congrats, since Gargoyle is really a good (and usefull) piece of software!
Missing links in Navigation Panel
Moderator: Moderators
Missing links in Navigation Panel
Hi, I've just upgraded Gargoyle from 1.3.3 to 1.3.9. I backed up the config before flashing the Fonera and restored right after upgrading. Everything is working fine except a few missing links from Navigation panels (on the left). Most notable missing links: DHCP settings (to set fixed IP-MAC pairs), port_forwarding (pretty self explanatory) amongst others.
Anyone with the same issue?
Anyone have suggestions on how to fix this behaviour?
Thank you in advance!
And congrats, since Gargoyle is really a good (and usefull) piece of software!
Anyone with the same issue?
Anyone have suggestions on how to fix this behaviour?
Thank you in advance!
And congrats, since Gargoyle is really a good (and usefull) piece of software!
-
DoesItMatter
- Moderator
- Posts: 1373
- Joined: Thu May 21, 2009 3:56 pm
Re: Missing links in Navigation Panel
1) Reset to defaults and re-flash 1.3.9 to be sure you got a good flash
2) Make sure you flush your internet browser caches
3) Try to do some configuring yourself to test
4) Once you're sure all the tabs are ok/working, then go ahead
and reload your config backup and see if that works.
2) Make sure you flush your internet browser caches
3) Try to do some configuring yourself to test
4) Once you're sure all the tabs are ok/working, then go ahead
and reload your config backup and see if that works.
Soylent Green Is People! 2x Asus RT-N16 = Asus 3.0.0.4.374.43 Merlin
2x Buffalo WZR-HP-G300NH V1 A0D0 = Gargoyle 1.9.x / LEDE 17.01.x
2x Engenius - ESR900 Stock 1.4.0 / OpenWRT Trunk 49400
Re: Missing links in Navigation Panel
I've got a couple of screenshots. Right after installing 1.3.9 I have all the links in left navigation panel. Next I restore old config and the links go away misteriously. Again.DoesItMatter wrote: 4) Once you're sure all the tabs are ok/working, then go ahead
and reload your config backup and see if that works.
Any different idea/suggestion?
-
DoesItMatter
- Moderator
- Posts: 1373
- Joined: Thu May 21, 2009 3:56 pm
Re: Missing links in Navigation Panel
My #1 suggestion would be to write down all your info
and re-configure by hand.
It is very unlikely - but I think I've experienced it once, where
the config file is corrupted and doesn't reload properly.
What version did you upgrade from?
If you did a huge jump, like from 1.3.1 to 1.3.9, try this.
Load up the old version, re-load that config file, make sure it all works.
Then go ahead and jump up 1 version, reload the config, and see if
it works ok. If it does, re-save a NEW config file and then try the
1.3.9 upgrade and reload the new saved config.
and re-configure by hand.
It is very unlikely - but I think I've experienced it once, where
the config file is corrupted and doesn't reload properly.
What version did you upgrade from?
If you did a huge jump, like from 1.3.1 to 1.3.9, try this.
Load up the old version, re-load that config file, make sure it all works.
Then go ahead and jump up 1 version, reload the config, and see if
it works ok. If it does, re-save a NEW config file and then try the
1.3.9 upgrade and reload the new saved config.
Soylent Green Is People! 2x Asus RT-N16 = Asus 3.0.0.4.374.43 Merlin
2x Buffalo WZR-HP-G300NH V1 A0D0 = Gargoyle 1.9.x / LEDE 17.01.x
2x Engenius - ESR900 Stock 1.4.0 / OpenWRT Trunk 49400
Re: Missing links in Navigation Panel
It's very unlikely but it's exactly what happened to meDoesItMatter wrote:It is very unlikely - but I think I've experienced it once, where
the config file is corrupted and doesn't reload properly.
I followed your directions and now everything looks OK, apart from a strange behaviour with DHCP/DNS that I'll dig later
Thank you.