Buffalo WHR HP G300N

[nchall]

Hi. This is a Atheros AR7240 chip with 32 MB Ram. Would it be possible to run Gargoyle on it? I'm trying to avoid DD-WRT and the stock firmware as they have limitations.

[DoesItMatter]

http://wiki.openwrt.org/toh/buffalo/start

Those are the current officially supported routers from Buffalo

Once OpenWRT supports a router, Gargoyle will usually
support it within the next 1 or 2 builds, depending when Eric
refreshes and updates to the current OpenWRT builds.

Might find more info in the OpenWRT forums on whether or not
this is a work-in-progress for the WHR-HP-G300N

[nchall]

Anyone have any more ideas about getting OpenWRT or Gargoyle running on this?

[nchall]

I now have OpenWrt running on this router using a trunk build and now just need to figure out how to install Gargoyle on it. Any ideas?

[nchall]

So no ideas on this? Supported in trunk here:

http://wiki.openwrt.org/toh/start#buffalo

[mix]

No idea.

[DoesItMatter]

Gargoyle only works with official releases from OpenWRT (Backfire)

Trunk would require a LOT of editing of the source as quite a few
things have changed.

If you need to use OpenWRT Trunk - you're stuck with OpenWRT for now

[nchall]

Ok thanks. Will post back when/if it becomes official.

[uggla]

This router has been in the openwrt trunk since (at least) January does that mean it should work with the latest Gargoyle?

[DoesItMatter]

It's reported as supported by the trunk versions which means
newer than Attitude Adjustment 12.09 official / Gargoyle 1.5.10

Don't flash Gargoyle on these yet - need to wait a bit

I used to have a WHR-HP-G300N but put it in use in a business office

It's running one of the trunk builds of Barrier Breaker

This is a fantastic router for range/signal/multiple wireless clients

Not supported by Gargoyle 1.5.10 though.