bricked dongle

[graffixx]

ok I blew it ...I was setting it up fpr wired and downloaded the gargoyle_1.5.1-wrtsl54gs-squashfs.bin file ,when i updated software on the xfta it went all the way through until it rebooted and then it locked up i gave it about 30 min. hoping and then rebooted it , now it wont connect did a netstat/a in cmd search and no ips present tried 192.168.1.1 .o2 .100 and everything else imaginable tried the 30/30/30 reset left it unplugged overnight still bricked ...anysuggestions and it is plugged in to my laptop diectly tried though lan port wnd wan port on the xfta thanks in advance Graffixx

[james20020]

i have the same problem there is a way to fix this?? and back to stock ?

[james20020]

i fix my i tell you the intruction to fix it
1. you need the program tftp2
2.need the bakup of your router because this image in the download are is not conpatible whit the dungle that image dont include the server section
if you dont have the image i goin to put here for you download
3.need to put static ip in your computer whit this ip
192.168.1.8
255.255.255.0 the save
4.conect the ethernet cable in port 1 in the router and to the pc
you need diable all wirrles network only you need the lan card enable
5.open the tfpt if you using windows vista or 7 run by admin the brouse the file you download in server pu 192.168.1.1 then click upgrade the router going to start flash when finish restart the router and now you have your router back to stock only you need is confic back good look

this is the image you can download from here when you download
http://www.megaupload.com/?d=X5135NID

[james20020]

i fix my i tell you the intruction to fix it
1. you need the program tftp2
2.need the bakup of your router because this image in the download are is not conpatible whit the dungle that image dont include the server section
if you dont have the image i goin to put here for you download
3.need to put static ip in your computer whit this ip
192.168.1.8
255.255.255.0 the save
4.conect the ethernet cable in port 1 in the router and to the pc
you need diable all wirrles network only you need the lan card enable
5.open the tfpt if you using windows vista or 7 run by admin the brouse the file you download in server pu 192.168.1.1 then click upgrade the router going to start flash when finish restart the router and now you have your router back to stock only you need is confic back good look

this is the image you can download from here when you download
http://www.megaupload.com/?d=X5135NID