I have just moved from DD-WRT to Gargoyle and quite like it. I switched primarily for the bandwidth quotas.
I run a WRT54GL with a single upgraded antenna (on the left side of the router when viewing from the front). DD-WRT would let me explicitly configure this.
To configure with Gargoyle, I assume I configure the following settings and simply restart the interface. Short of experimenting (which I should probably do anyway) can anyone confirm I have the right txantenna/rxantenna settings based on my configuration? I cannot find a reliable source for this.
option 'diversity' '0'
option 'rxantenna' '1'
option 'txantenna' '1'
Thx... especially for doing such a nice job on Gargoyle.
/etc/config/wireless settings for WRT54GL
Moderator: Moderators
Re: /etc/config/wireless settings for WRT54GL
The Gargoyle interface does not support antenna selection but perhaps some Gargoyle user will chime in on this. If not your odds would be better over at OpenWRT.org for such topics.
Linksys WRT1900ACv2
Netgear WNDR3700v2
TP Link 1043ND v3
TP-Link TL-WDR3600 v1
Buffalo WZR-HP-G300NH2
WRT54G-TM
Netgear WNDR3700v2
TP Link 1043ND v3
TP-Link TL-WDR3600 v1
Buffalo WZR-HP-G300NH2
WRT54G-TM