hellbound1988, dreams_idea: Try again now, with the new ar71xx images I just uploaded for 1.4.2
There was a build configuration issue (see update added to original post), which caused USB modules to be included incorrectly. This caused problems because the image was then too big for the router, which only has 4MB of flash space. I've now recompiled images for this and other ar71xx models without USB ports to exclude the unnecessary USB modules and get the firmware down to the right size (though just barely).
mix: No, there are (or can be, if you have enough features being used) genuine memory issues when you have only 16MB of memory. It's just that on higher-memory systems the output was also (erroneously) listing a lot of memory being used. This fixes that.
Regarding the theme menu: Try rebooting, and see if it pops up. You need to reboot after installing a theme before you'll see the menu. If it still doesn't show up you may be suffering from a problem with the original images due to the build-configuration error referenced above, and you should try again with the latest images.
Eric thank you for your work on Gargulye:)
I have a router TL1043ND.
After the firmware update to 1.4.2 the memory usage actually decreased from 90% to 40%:)
I would like to ask whether it can be added to the WEB interface:
1. Packet forwarding GRE to connect to the internal VPN server LAN from the Internet for example or network.
2. Can I do something wrong doing, but I have configured a DHCP server router, but if you specify a DNS server other than the DNS server of the router, DHCP clients will still be assigned a DNS server the router because of this network sites do not open.
Sorry for my bad English.
Dimidrol wrote:...
2. Can I do something wrong doing, but I have configured a DHCP server router, but if you specify a DNS server other than the DNS server of the router, DHCP clients will still be assigned a DNS server the router because of this network sites do not open.
Sorry for my bad English.
Try to go to "Connection" -> "Basic" -> "Local Network / LAN"
Where you are asked "Allow Alternate DNS:" you should choose "Allow Clients To Use Alternate DNS Servers".
My RSPro had problems with post 1.3.14 versions when trying to use Client+AP mode. The client simply wouldn't connect. This version connects and works great!'
Now I'll put it on my Buffalo. That's my main gateway. I'll report back.
Memory usage really is better. Below some found issues:
- The system doesn't auto-connect PPOE Connection on boot. It used work on previous version.
- The system doesn't save fixed IP configuration. It used work on previous version too.