Hi all
I've just installed Gargoyle 1.2.5 (since this is the latest stable)
But, I can't figure how how to enable/turn on DNSMASQ
There was no file /etc/dnsmasq.conf, I tired creating one (with script) and rebooting but still no good.
I have used this with Tomato but want to move to Gargoyle because it has a much better IP Accounting capability (tomato has none)
Help! Can't see any documentation on this.....
Enable DNSMASQ
Moderator: Moderators
Re: Enable DNSMASQ
You should switch to v1.3.16 because even though it is not listed as a "stable version" it is much better than v1.2.5.
To your question dnsmasq is the default (and only) dhcp service in v1.3.16 and I do not know about v1.2.5. The file /etc/dnsmasq.conf also exists in v1.3.16.
Chow
To your question dnsmasq is the default (and only) dhcp service in v1.3.16 and I do not know about v1.2.5. The file /etc/dnsmasq.conf also exists in v1.3.16.
Chow
Linksys WRT1900ACv2
Netgear WNDR3700v2
TP Link 1043ND v3
TP-Link TL-WDR3600 v1
Buffalo WZR-HP-G300NH2
WRT54G-TM
Netgear WNDR3700v2
TP Link 1043ND v3
TP-Link TL-WDR3600 v1
Buffalo WZR-HP-G300NH2
WRT54G-TM
-
- Posts: 19
- Joined: Fri Jul 15, 2011 6:55 am
Re: Enable DNSMASQ
100% - Thank you....upgraded to v3...there it is...