Hi Lantis,
Is base_on_openwrt_2410 stable enough to build and run?
Thanks
base_on_openwrt_2410
Moderator: Moderators
Re: base_on_openwrt_2410
Not quite yet, give me a few more days.
I’ve only tested x86/64 and mediatek/filogic, and have only committed the former.
I’m doing a bulk update of all packages to their latest available (I’m past halfway). Will then check all targets compile successfully and push them in.
I’ve only tested x86/64 and mediatek/filogic, and have only committed the former.
I’m doing a bulk update of all packages to their latest available (I’m past halfway). Will then check all targets compile successfully and push them in.
https://lantisproject.com/downloads/gargoylebuilds for the latest releases
Please be respectful when posting. I do this in my free time on a volunteer basis.
https://lantisproject.com/blog
Please be respectful when posting. I do this in my free time on a volunteer basis.
https://lantisproject.com/blog
Re: base_on_openwrt_2410
No worries, I'd rather wait until it's stable enough to run daily.
Thanks
Thanks
Re: base_on_openwrt_2410
I did a successful build of base_on_openwrt_2410 for bcm53xx, the image is about 130KB bigger than my 23.05 builds but I assume that's because of openwrt-24.10.
I'm not going to flash it, I just wanted to see if it would build. I will rebuild and flash when it's ready for testing.
Cheers
I'm not going to flash it, I just wanted to see if it would build. I will rebuild and flash when it's ready for testing.
Cheers
Re: base_on_openwrt_2410
Alright I've put one of these images into production for my home network and so far so good.
I have a reasonable level of confidence so far, will know more in a few days.
I have a reasonable level of confidence so far, will know more in a few days.
https://lantisproject.com/downloads/gargoylebuilds for the latest releases
Please be respectful when posting. I do this in my free time on a volunteer basis.
https://lantisproject.com/blog
Please be respectful when posting. I do this in my free time on a volunteer basis.
https://lantisproject.com/blog
Re: base_on_openwrt_2410
Sounds good, I will do a build and test.
Thanks
Thanks
Re: base_on_openwrt_2410
So far so good. The only thing I've noticed is I'm still getting the fw4 IPv6 errors when saving settings.
Cheers
Cheers