Failed to build 1.12

[raven]

Hi Lantis, this is my config https://pastebin.com/raw/AaHHtBvi

[Lantis]

Config looks ok.
What command are you using to start the build?

[raven]

I used command make ar71xx.glar150

[Lantis]

Try
make FULL_BUILD=true ar71xx.glar150

Without doing full build at least once, you don't get the patched kernel modules.

[raven]

If I use the full build when compiling, will the completed image will use the config I created?

[Lantis]

By config do you mean the build config which I assume you called ar71xx.glar150?
If so, yes.

If you're trying to pack custom Configs into /etc/config, no.
But, once you do one full build, you should be able to do follow up rebuilds using this technique.

[raven]

Ok, I'll try using full build and see what happened. I'll get back to you with the result later.

[raven]

Hi Lantis, finally I managed to compile successfully, install and reboot. And now I have a problem that I just found, I haven't encountered any other problems besides this because of my limited time to test each function. I'll report it and ask again if I find it. For now the problem that I find is on the plugins page it says 'An Internet connection is required to Refresh Plugins' even though my router is connected to the internet and I can open websites. And when I press the refresh plugins button, the plugins are not refreshed but remain the same when they haven't been refreshed. Could this be because I made a mistake while compiling ?. Or is this normal and I have to install it manually?

[Lantis]

Well done.

What connection method are you using on the Connection Basic page?

[raven]

I'm using usb modem 4G (Hilink,RNDIS) configured as gateway