1.13.x with IPv6 Test Build - 20200619

[Lantis]

Don't preserve settings from 1.12 to 1.13.
Addtionally if you are using wireless bridge config, you should wait for the next build where I fixed an error causing the exact symptom you are describing.

[wbennett88]

Don't preserve settings from 1.12 to 1.13.
Addtionally if you are using wireless bridge config, you should wait for the next build where I fixed an error causing the exact symptom you are describing.

Attempting to preserve settings was probably what caused my problem. I tried resetting the router and reflashing the firmware but the problem persisted. I was able to go back to 1.12 and reconfigure and all is good. I am using the router as a gateway with DHCP turned off, a static address and my main router for DNS. (Dumb AP)

If there is nothing in this setup that prevents me from upgrading to 1.13 I hope to try again tomorrow without preserving settings.

[Lantis]

If you have it in a configuration that doesn't have WAN, you will have trouble.
Your description doesn't really match what I would call Dumb AP, so I am not certain you will be affected.

[wbennett88]

Sorry, forgot to mention that I have Wan disabled.

[wbennett88]

OKay, I reflashed 1.13 and this time I did not preserve settings. I was able to setup the router as a "DumbAP". Setup as Gateway, I disabled the wan and DHCP, gave it a static IP and put the main router as the DNS.

The router seems to be operating just fine but I am still having the same GUI problems. I can get to the login page but once logged in the GUI disappears and I just see the purple background. I don't have any GUI issues with 1.12.

Any suggestions?

[Lantis]

It is the same issue as already described. You can build from the latest code or wait for someone else to do so for you

[wbennett88]

It is the same issue as already described. You can build from the latest code or wait for someone else to do so for you

Thanks Lantis, I will wait for your next build.

[wordpr3ss]

Thanks a lot for fixing the "BSOD" problem

I tried 1.13.0.x gargoyle-ispy 2020-August-17 19, still having trouble with repeater mode (Model:NETGEAR WNDRMACv2):
I can't access anything if I connected to the repeater wifi. I won't get an ip assigned by the AP dhcp. I can't access anything even if I manually set an ip/gateway in AP's subnet.

However I can ssh into the the repeater through its relay IP (10.0.0.6) from the AP,and I checked the routes, looked fine, and the repeater itself can reach the AP/internet.

Not sure how to debug further. I don't have ipv6 setup but not sure if or how to determine that's the problem.
I wish I could debug more, but my skill here is limited

couldn't make the image work here.
https://ibb.co/ggbTS0H
https://ibb.co/646kk9X




Thanks again for the gargoyle build!

[Lantis]

Is your upstream AP also Gargoyle? If so, ensure that "Enforce DHCP Assignments" is disabled.

Other than that, your settings look OK.

[wordpr3ss]

Thanks for looking into it.
The upstream AP is ddwrt (no openwrt supported due to tainted kernel, i guess).

The exact setup works for gargoyle 1.12.

If it's just dhcp, manually setting up IP should work, but it didn't. So I suspect it's something more.

Is your upstream AP also Gargoyle? If so, ensure that "Enforce DHCP Assignments" is disabled.

Other than that, your settings look OK.