Bandwidth Monitoring Not Working on new Gargoyle 1.12 WRT32X

[agrohe21]

wondering if maybe I am missing something. The internet is working and webmon features are working but /tmp/data/bwmon is empty and web page is empty.

[Lantis]

Try /etc/init.d/bwmon_gargoyle restart

[RomanHK]

Try one more command to be sure, so the whole procedure should be:

Code: Select all

/etc/init.d/bwmon_gargoyle enable
/etc/init.d/bwmon_gargoyle start

[agrohe21]

Tried both of those to no avail. Should I reflash an upgrade? I went from stock firmware to Gargoyle. Everything else is working fine other than this, which is the reason I run Gargoyle.

[RomanHK]

1. Do you use Gragoyle as a gateway (WAN on the Internet, LAN computers)? or as a bridge (switch)?
- but if you use Gargoyle as a bridge or switch, these features will not work.

2. As an alternative, try resetting the configuration to default and starting from scratch.

[agrohe21]

Yes, I use gargoyle as the gateway with the Comcast modem going straight to the internet/wan port on the 32X. That connection is good and fast 300Mb+ speed. I turned off wireless and connected 1 lan port to a switch and the switch to an Orbi 3 node network for wireless.

I did copy ethers and quotas over from my Archer c7 setup. let me try the reset option and start from there to see what happens before I copy over the old files. BTW, I dont copy them, I edit the files and insert the old content into the new file.

[agrohe21]

As far as I can tell, resetting the configuration means applying the sysupgrade firmware, correct? there is no other way to reset to factory that I see in 1.12.

Nm found it in backup section.

[RomanHK]

As far as I can tell, resetting the configuration means applying the sysupgrade firmware, correct?

Just press this button :

[agrohe21]

Yeah, found that. Reset and now it is working. Will port over the ethers and other stuff and make sure it is working each time after the copy/edit.

would have liked to know what is wrong but it is working anyway.

[agrohe21]

I have now found that when I paste my old hosts into the new file, the bwmon stops working.

I see two lines for gargoyle. One has comment to not touch/remove. the other one seems to have to be the line before it. I had pasted my hosts in between and that seemed to be the issue. hopefully that solves it.