1.3.10 Nanostation2 Settings lost everytime

[scalawag]

Hi.
I installed 1.3.10 on my Nanostation2 but it seems it doesn't save the settings anymore
I have to manually configure it on every reboot or powerdown.
1.3.9 worked fine.
PS: I didn't upgrade from 1.3.9 to 1.3.10. I did a fresh install with tftp.

[DoesItMatter]

UBIQUITI NANOSTATION LOCO2 WIRELESS CPE OUTDOOR 8DBI DUAL-POL 802.11b/g

NanoStation Loco provides a breakthrough in cost, reliability, performance. Features up to 10km of range performance, 25+Mbps of throughput performance, & the powerful, intuitive AirOS by Ubiquiti. NanoStation Loco is the latest innovation in broadband wireless CPE technology from Ubiquiti.

Features Include:

Processor Specs: Atheros MIPS 4 KC, 180MHz

Memory Information: 16MB SDRAM, 4MB Flash

Networking Interface: 1 X 10/100 BASE-TX (Cat. 5, RJ-45) Ethernet Interface

Approvals: FCC Part 15.247, IC RS210, CE

----------------------

Also see this thread:

http://www.gargoyle-router.com/phpbb/vi ... 1133#p5442

I think these 4MB flash / 16MB ram routers are just too small