D-link dir850L ac1200

[L0RDZ1C4]

Hi, i need your help people, i have a D-Link dir850L router ac1200, and i wanna put a gargoyle firmware, because the original D-Link's firmware is very limited . What do you recommend?
Thanks for your help!

Info:
D-Link Dir-850L
Rev: B1
CPU1: Realtek RTL8197D (660 MHz)
FLASH: 128 MiB (Spansion S34ML01G100TFI00)
RAM1: 128 MiB (Nanya NT5TU64M16CG-AC)

[nworbnhoj]

I see a D-LINK DIR-857 on the openwrt website - but no mentino of the DIR-850. Can you provide some additional details regards memory etc?
https://wiki.openwrt.org/toh/d-link/dir-857
https://www.gargoyle-router.com/wiki/do ... ed_routers

[L0RDZ1C4]

So i edited the post with the Info, but
i put again

Info:
CPU1: Realtek RTL8197D (660 MHz)
FLASH: 128 MB
RAM1: 128 MB
WI1 chip1: Realtek RTL8812AR
WI1 802dot11 protocols: an+ac
WI1 MIMO config: 2x2:2
WI1 antenna connector: U.FL
WI2 chip1: Realtek RTL8192CE
WI2 802dot11 protocols: bgn
WI2 MIMO config: 2x2:2
ETH chip1: Realtek RTL8197D
Switch: Realtek RTL8367RB
LAN speed: 10/100/1000
LAN ports: 4
WAN ports: 1

THANKS

[nworbnhoj]

So there is plenty of CPU and memory but no obvious openwrt or gargoyle support. I suggest that you post in this thread
viewtopic.php?f=13&t=7861

[L0RDZ1C4]

Thanks man,
One more question, will be the openwrt's firmare dir-857 Or gargoyle's firmware dir 825l will work on my router?

[nworbnhoj]

Maybe yes - Maybe no. @Lantis will respond to your post in the other thread and give you a better answer to this question

[qzzipc]

Sorry, old topic, but i want gargoyle also on a dir-850l. but the question is, is it possible to flash a custom rom on this router?? Its the most beautifull router for in the living room ever seen. But without a custom rom is the router not good enough...

[Lantis]

I'm not aware of any third party support for this one.