Does Linksys E3000 Dual-Band Wireless Router work?

[avamk]

Hello,

Newbie question: does the latest version of Gargoyle work on the Linksys E3000 Dual-Band Wireless Router? If so, how should I install it? If not, is there an alternative open source firmware that might work on it?

Thank you very much.

BTW, here are its specs:

CPU Broadcom BCM4718 480 MHz
Flash ROM 8 MB
RAM 64 MB
Radio simultaneous 2.4 GHz, 5 GHz
WLAN Support a/b/g/n
WLAN Max Speed 300 mbps
Antenna Location Internal
Switch 4x GigE + 1 WAN
USB 1x USB 2.0

[Gingernut]

I believe it's not supported by Gargoyle or Openwrt either at this point.

Have a look here: http://tomatousb.org/forum/t-284328/alp ... -for-e3000

[avamk]

I believe it's not supported by Gargoyle or Openwrt either at this point.

Have a look here: http://tomatousb.org/forum/t-284328/alp ... -for-e3000

OK, thank you. Hopefully someday it will be supported.

[callsignapollo]

I was looking at upgrading to this router from my WRT54GL.

Has anyone tested Gargoyle on it?

Routers that support Gargoyle are not easy to find in Australia.

[callsignapollo]

Hi All.

Is there any update on support for the E3000?

I've been using TomatoUSBv54 for some time now without any issues. I just miss Gargoyle and the per-client bandwidth usage goodness.

Thanks

callsignapollo