From Gargoyle to LEDE

General discussion about Gargoyle, OpenWrt or anything else even remotely related to the project

Moderator: Moderators

Post Reply
Cornholio
Posts: 27
Joined: Thu Aug 17, 2017 9:52 pm

From Gargoyle to LEDE

Post by Cornholio »

Should I use the factory bin file first or can I just flash the sysupgrade bin file directly?
Top
Diz
Posts: 18
Joined: Fri Dec 02, 2016 5:27 pm
Contact:
Contact Diz

Re: From Gargoyle to LEDE

Post by Diz »

I used the sysupgrade bin file through the gargoyle firmware upgrade page and it worked fine for me.
Linksys WRT1200ac on 1.9.X
Top
d3fz
Posts: 277
Joined: Sun Aug 28, 2016 7:34 pm

Re: From Gargoyle to LEDE

Post by d3fz »

Sysupgrade.bin file will work just fine.
TP-Link Archer C7 v2 - Gargoyle 1.12.X
TP-Link WR842ND v2 - Gargoyle 1.10.X
TP-Link RE450 AC v2 - Stock FW 1.0.4
TP-Link WA850RE v1.2 - LEDE 17.01.1
Top
Cornholio
Posts: 27
Joined: Thu Aug 17, 2017 9:52 pm

Re: From Gargoyle to LEDE

Post by Cornholio »

Appreciate the help, but I can't make it to work so I went back to Gargoyle. :D
Top
d3fz
Posts: 277
Joined: Sun Aug 28, 2016 7:34 pm

Re: From Gargoyle to LEDE

Post by d3fz »

Even better. 8-)

Was there a specific feature in LEDE that you were after ?
TP-Link Archer C7 v2 - Gargoyle 1.12.X
TP-Link WR842ND v2 - Gargoyle 1.10.X
TP-Link RE450 AC v2 - Stock FW 1.0.4
TP-Link WA850RE v1.2 - LEDE 17.01.1
Top
Cornholio
Posts: 27
Joined: Thu Aug 17, 2017 9:52 pm

Re: From Gargoyle to LEDE

Post by Cornholio »

d3fz wrote:Even better. 8-)

Was there a specific feature in LEDE that you were after ?
I was trying to check it's SQM feature but unfortunately I don't know how to make it work as I'm not that tech-savvy with networking. Unlike Gargoyle, I can just choose DHCP wired from the drop-down menu and connect the router to my modem which is in bridge mode.
Top
Post Reply

Return to “General Discussion”