Hi !
I am new to Gargoyle but I heard many good things about it. Just installed it on a Archer C7 V2 and I like the clean, polished interface. My only problem is that I do not see VLAN support anywhere in the GUI. I could create them in command line but I saw a post regarding Gargoyle 1.6.2 where the VLAN config was being overwritten by the Connection section of the GUI. Is the situation still the same in 1.9.2 ? Is there a plugin available or perhaps a roadmap for support ? Otherwise I´ll have to go to Lede/OpenWRT/LuCI.
Gargoyle 1.9.2 on TP Link Archer C7 V2 VLAN support
Moderator: Moderators
Re: Gargoyle 1.9.2 on TP Link Archer C7 V2 VLAN support
No GUI for it, and I don't think there are any plans.
Yes the connection basic page will overwrite your settings when saving.
But if you set everything up first, then do your VLANs you should be ok.
Yes the connection basic page will overwrite your settings when saving.
But if you set everything up first, then do your VLANs you should be ok.
https://lantisproject.com/downloads/gargoylebuilds for the latest releases
Please be respectful when posting. I do this in my free time on a volunteer basis.
Please be respectful when posting. I do this in my free time on a volunteer basis.