Operating mode: AP+WDS
Successfully connected to this router WR1043ND Router and WA801ND Access Point. All two use stock firmware from TP-Link.
#ifconfig
Code: Select all
wlan0 Link encap:Ethernet HWaddr D8:5D:4C:BF:25:B4
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:179 errors:0 dropped:0 overruns:0 frame:0
TX packets:4309 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:15396 (15.0 KiB) TX bytes:947551 (925.3 KiB)
wlan0.sta Link encap:Ethernet HWaddr D8:5D:4C:BF:25:B4
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:17175 errors:0 dropped:0 overruns:0 frame:0
TX packets:1511 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2061302 (1.9 MiB) TX bytes:530987 (518.5 KiB)
wlan0.sta Link encap:Ethernet HWaddr D8:5D:4C:BF:25:B4
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:521 errors:0 dropped:0 overruns:0 frame:0
TX packets:891 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:371946 (363.2 KiB) TX bytes:174608 (170.5 KiB)
Code: Select all
wlan0 IEEE 802.11bgn Mode:Master Frequency:2.432 GHz Tx-Power=27 dBm
RTS thr:off Fragment thr:off
Power Management:on
mon.wlan0 IEEE 802.11bgn Mode:Monitor Tx-Power=27 dBm
RTS thr:off Fragment thr:off
Power Management:off
wlan0.sta1 IEEE 802.11bgn Mode:Secondary Tx-Power=27 dBm
RTS thr:off Fragment thr:off
Power Management:off
wlan0.sta2 IEEE 802.11bgn Mode:Secondary Tx-Power=27 dBm
RTS thr:off Fragment thr:off
Power Management:off
And there is ... nothing!
So it looks like there are no wireless connection to this router, while there are at least two links established.
What module should I use to check that actual WDS connection is established, and (if possible) current link status (RSSI, bitrate, etc.)?
Thank you for explanation on subject.