Internet speed TP-Link TL-WDR3600 v1

[chandran]

Dear sir

i have TP-Link TL-WDR3600 v1 with gargoyle 1.9.2 installed
i am usingACT broadband with incoming speed of 60mbps
but my router both via wired as well as as via wifi gives 25 to 30 max mbps
any idea what to do?

[ericwong]

Read this or similar post
viewtopic.php?f=8&t=10897#p44677

In short, you need a router with faster CPU unless you change your settings.

[chandran]

i have only enabled quota not qos,
if i disable quota some 4 to 5 mbps change happen. that is i could get up to 34 -35mbps i need to check by flasing company firmware and see if same happens

any way can you tell which is the router which can give this speed, so that i can buy he same

[ispyisail]

Its the number one complaint with Gargoyle at the moment.

[ispyisail]

TP-Link Archer C7 V2 Gargoyle
Linksys WRT1900AC V2 Gargoyle

[chandran]

As for checking i flashed the TP Link firmware, and surprised to see speed of 60mbps. Flashed Back Gargoule 1.9.2 removed all restrictions, quotas, mac filtering etc. then it give 35 to 40mbps.

when i removed all the restrictions settings are equal to OEM. So i think some improvement needed in the Gargoyle or can have a separate setting to enable the full capability of the router

[jayray]

I'm not at my home ATM, but as I recall, when you enable QOS there is a setting for maximum throughput measured in kbps somewhere near the bottom. The default kbps is quite low. You'll have to change that manually to better reflect your actual throughput on both upload and download qos pages.

You said qos isn't enabled but it sounds like it might be.

[Lantis]

The firewall processing takes time in the CPU. Limits top speed.
It is what it is.

[chandran]

Thanks to jayraj and lantis

enabling QOS it become bad

again CPU issue

no rules are enabled by me at present. so fire wall taking time is some thing i doubt

if with same cpu native firm ware able to do better and almost same setting of Native firmware it must minimum mach performance thats what i feel

[Lantis]

Even with no rules it takes time and CPU cycles.

Stock firmware uses hardware NAT acceleration to speed up. This isn't available in ANY third party firmware.
It is just the way it is I'm sorry.