AP setup help.

[riaz]

I'm using a device called OMW from anaptyxmesh to do all my dhcp routing. I have an MR3201a with gargoyle on it. I want it to take the signal from the OMW and repeat the signal.

Internet -> OMW ->wired-> MR3201a

what settings should i be setting gargoyle up with?

I've tried it as a gateway, under connect to internet i say DHCP wired, and WAN. then under Router IP i give it 101.245.47.2 and the Gateway i set at 101.245.47.1 (thats the IP of the OMW)

And I put it in AP mode, and put set the wireless SSID.

Its not working, what am i doing wrong?

[DoesItMatter]

You want to choose Client + AP mode

Choose DHCP Client on the WAN side, so the MR3201a gets an IP

On the Wireless - setup an AP

What you have to decide on is whether or not you want the
wireless clients to be on their own subnet or not.

[riaz]

Thanks for the help. Unfortunately I'm still not getting it.

I don't see Client + AP anywhere.

At the very top: Gateway or Wireless Bridge?

If its gateway:
Connect via: DHCP (wired)
Ethernet port: WAN

LAN
Router IP: should this be this device, or the device doing all the dhcp routing?

Wireless:
AP, AP+WDS, or AD HOC?

Then under DHCP
I turn the LAN DHCP server off right?

[pbix]

What version of Gargoyle are you using?

If you select 'bridge' at the top you will see the desired selection under the wireless pick in the bottom section.

[riaz]

I'm using Gargoyle 1.25 for MR3201a.

Ok, I hit wireless bridge at the top:
then I get the options Router IP and AP/Gateway IP.
Router IP should be this device correct?
and AP/Gateway IP should be the device doing all the DHCP?

then under Wireless i have 2 options:
"Connect via WDS"
"Connect via Client Bridge"

I choose Client Bridge
and put repeater on enabled.

Doesn't seem to be working.

[pbix]

Please upgrade to v1.3.5. I think you will find what you are looking for.

[riaz]

I just upgraded to 1.3.5, and the Connection page looks exactly the same as 1.2.5. I also made sure it was 1.3.5 that I was looking at.

The settings I've mentioned above are those that I see for both, Gateway and Wireless Bridge / Repeater.

[riaz]

Ok I found client + ap mode.

I had to choose gateway.
then Connect Via: DHCP (Wireless)
then at the bottom I get the Client + AP mode.
I chose that.
Then on the very left I chose DHCP and turned it off.

Doesn't seem to be working still.
I want another unit to be doing all the DHCP routing. The gargoyle MR3201A is wired to it. And I want the MR3201A to be a wireless AP to my other main gateway device.

What should my configuration be?

thanks