Version 1.9.1

[Lantis]

I have upgraded today successfully from 1.8.1 (wa901nd) to 1.9.1

in Basic Settings the "Transmit Power:" is now max 24
in 1.8.1 I could set 30 (max)

is there a patch to get 30 Transmit power back ?

If your country's regulatory standards do not allow you to transmit at 30dBm then no.

[racy]

Hi,

My router is a tplink 1043nd v1 ... I was using 1.9.0 and I upgraded to 1.9.1 ... I didn´t save the settings and my router is "dead" now .... failsafe doesn´t work because the SYS led is off ... TFTP upload didn´t work also .... so be careful ....

Best Regards

RACY

[Naevus]

My router is a tplink 1043nd v1 ...

Do you have External USB Flash for extend memory?
I have one. And I can't flash 1.9.1 over 1.9.0. (see some pages ago). I take off USB flash and I try again. And I have brick.

But I use USB-TTL adapter and restore flash (1.9.1) from first try.

[racy]

Hi, I didn´t have External USB Flash for extend memory

I aldo used USB-TTL adapter and restore flash (1.9.1) and now it is working.

I don´t know why when I upgraded it , it broke ... because I din´t save the settings ... anyway ... now I am happing using 1.91

best regards

[veeraragavan_n]

Gargoyle is so much better to use & navigate than luci thanks for the new release.

But when I login to my banking site icici.com, the router it seems goes incommunicado, none of the devices an connect to Wi-Fi anymore till I restart the router.

Anybody else with the same or similar experience?

[deanMKD]

For me Gargoyle 1.9.1 worked very good, better then 1.6.2 that i used before. I notice speed improvment from previous build. Now i get full speed from my ISP.

Device: MR3020 4MB Flash 32MB RAM. Great Job !

[lollapalooza]

I'm not chasing, just curious
Do we have any news on when 2.0 stable will be released?

[lpacheco]

Would the next stable version be a 2.0 or a 1.10?

[sajjadhalai]

I m using Bfallo WZR 600DHP/
If quota is ended then user should be redirected to ROUTER login page i.e Quota page.... but it is not working in this version.. user are not redirected to warning(login page) page of qouta..

[d3fz]

I m using Bfallo WZR 600DHP/
If quota is ended then user should be redirected to ROUTER login page i.e Quota page.... but it is not working in this version.. user are not redirected to warning(login page) page of qouta..

Hi sajjadhalai,

report this issue into the forum below, it could be someone else's problem as well.

http://www.gargoyle-router.com/phpbb/viewforum.php?f=12