gargoyle-ispy 2016-May-25 20:28.torrent

[dancardwell]

Hi, I'm on an Archer C7v2 (older version of V2) on build 1.9.X (Built 20160219-0158 git@3969110) can I preserve setting when upgrading to this build? Or will it mess up? Planning to upgrade this week.

[tapper]

Hi, I'm on an Archer C7v2 (older version of V2) on build 1.9.X (Built 20160219-0158 git@3969110) can I preserve setting when upgrading to this build? Or will it mess up? Planning to upgrade this week.

Hi sorry to say no. There was a new 5ghz driver and it messes up if you save settings. If you make a back up you can use WINscp to transfer some of the files across. The ones that are safe to moov across are:
/etc/config/firewall
/etc/config/qos_gargoyle
/etc/ethers
/etc/firewall.user
/etc/hosts

[Krog]

ispy is posible a hardware accelerated nat in gargoyle?

i keep testing in wdr3600 all is good yet

[ektus]

I came finally around to installing it on my Archer C5 V1.2. Seems to be working so far, but I haven't been able to reliably connect to the DSL router using 5GHz WiFi. 2.4GHz works fine after adjusting the country (need channel 13), but 5GHz doesn't seem to work. WiFi scan on the connection page only shows 2.4GHz channels. iw wlan0 scan in a SSH session shows the DSL router just fine.

[edu]

This is a great build!
eth seens to run a lot faster!
TP-WDR-4300 v1

[Lantis]

ispy is posible a hardware accelerated nat in gargoyle?

i keep testing in wdr3600 all is good yet

No sorry

[jimkas]

Upgraded from 1.8.1 to this version on a tl-wdr3600.
I have a problem with my Dynamic DNS Services (no-ip.com and dnsomatic.com). When i add a service and press save changes the message that appears "Please Wait While Settings Are Applied" never go away. So i refresh my webpage, i see at the bottom my added service but it never gets updated. Any solution please?

[Lantis]

DDNS known issue. I'm still trying to figure out why it is broken.

[Himmig]

I updated to this version on Archer C7 v2(old) and it is running very smoothly and I am excited to report that this is the first version where Wireless Gateway + AP works on both 5GHZ and 2.4GHZ.

Well done guys!

[trance89]

hi ispy
is it possible to add MiWifi Nano in your next build? lot of people would appreciate that
https://downloads.openwrt.org/snapshots ... pgrade.bin
thanks