Can't see the router
Moderator: Moderators
Can't see the router
Ok, soo.. I did a stupid mistake trying to bridge my ISP DNS servers onto my LAN. I changed it to bridge, then setup custom IPS for the DNS servers. Then, I guess I changed an IP that I wasn't supposed to. I can no longer get to my router via cable in the LAN port or using wireless, infact there is no longer any wirless that can be detected by my computer. I'm using a TP-Link router. Is there a hard reset option with gargoyle to set it back to default? Thanks! I just want to be able to have access to my router again.
Re: Can't see the router
I am also going to try an SSH session in failsafe mode. However, it's been a while since I've played with Linux command line. If I get in, does anyone know a direct path that would do a full configuration reset?