MAC filtering via gargoyle

[erez669]

i have gargoyle v1.8.1 installed and i can't find how to block specific mac address on your interface, how can i do that?
thanks

[ispyisail]

assign a static IP to the client

http://www.gargoyle-router.com/wiki/doku.php?id=dhcp

Then create a restriction

http://www.gargoyle-router.com/wiki/dok ... strictions

[tapper]

Hi under Connection Basic.

Wireless MAC Filter:
Enabled

MAC filtering applies to all wireless interfaces, including those in client mode. In client mode you must be sure to allow the MAC address of the AP to which you are connected.
MAC Filter Policy:
Deny Only MACs Listed Below
Or Allow Only MACs Listed Below

[erez669]

you can give me a screenshot because i can't find this option from some reason.

[Rocket222]

Sorry for bring up this old thread. But I have a similar problem that I cannot see the Restrictions under Firewall on my configuration. I am using Gargoyle Version 1.12.0. The only options under Firewall are Connection Limits, QoS(Upload) and QoS(Download). Is there a plugin that I need to install to see the Restrictions option?

[Lantis]

Restrictions are not available in bridge mode. Are you using a different connection method?

[Rocket222]

Yes. I am using the router as repeater. Is there any way to avoid certain device connecting to the repeater?

My setup contains a main router (dd-wrt) and two repeaters (one with dd-wrt and another Gargoyle). I want the repeater running on dd-wrt connect directly to the main router, instead of through the Gargoyle repeater.

[Lantis]

You'll need to check with ddwrt support, but on Gargoyle you would use the "bssid" option to make sure it connected to the correct upstream network.

I'm 90% sure it works the same way in dd-wrt, but I don't know.

Otherwise, you could maybe do MAC restrictions at the Wi-Fi level, but this would be done on the command line and I don't know how this works in a repeater style config.