I just got a TPlink WDR3600 and new to Gargoyle. I installed the 1.8.0 and Wifi down/upload speeds were 75/5Mbps which is household internet bandwidth limit tested with speedtest.net.
Problem is after turning on the QoS upload and download service with default settings, speed goes down to 3/0.3Mbps.
I downgraded to 1.6.2 and QoS performance is the same. What am I supposed to do with QoS?
Thanks.
Very poor QoS performance
Moderator: Moderators
Very poor QoS performance
Last edited by Sekrit on Wed Sep 30, 2015 12:41 am, edited 2 times in total.
Re: Very poor QoS performance
Did you read any of this?
http://www.gargoyle-router.com/wiki/doku.php?id=qos
or these
http://www.gargoyle-router.com/wiki/dok ... _scenarios
3mbps down and 0.3mbps up are the DEFAULT settings which i suspect you forgot to change.
Look for "Total (Upload) Bandwidth" and "Total (Download) Bandwidth" on each settings page.
http://www.gargoyle-router.com/wiki/doku.php?id=qos
or these
http://www.gargoyle-router.com/wiki/dok ... _scenarios
3mbps down and 0.3mbps up are the DEFAULT settings which i suspect you forgot to change.
Look for "Total (Upload) Bandwidth" and "Total (Download) Bandwidth" on each settings page.
https://lantisproject.com/downloads/gargoylebuilds for the latest releases
Please be respectful when posting. I do this in my free time on a volunteer basis.
Please be respectful when posting. I do this in my free time on a volunteer basis.
Re: Very poor QoS performance
I missed the part that said increase your total bandwidth value. After doing that, it was close to the highest bandwidth minus the overhead. Thanks. I went back to version 1.8.0.