cant access tplink 4300 after install Gargoyle firmware

[ronendinio]

hey
i have tplink 4300 router. i installed gargoyle firmware and it made its successfully.
after the router reboot i was able to get into it but after 3-2 secs its stuck and after that i couldnt get into the router. i made another reboot and now i get 169.254 ip adress and cant accsess.
i try to make reset but its seem the button doesnt work anymore.
what else can i do?

[nworbnhoj]

Some first steps would be to:
Connect a LAN port on your PC to a LAN port on the 4300
Manually set a static IP address on your PC to 192.168.1.2
browse to 192.168.1.1
use password and configure Gargoyle

if nogo then open a terminal and
ping 192.168.1.1
ssh root@192.168.1.1
use password
At the Gargoyle prompt type firstboot and wait until the command finishes
power cycle the router
browse to 192.168.1.1 etc

http://www.gargoyle-router.com/wiki/dok ... e_recovery

let us know how you get along!