TL-WR1043ND port forward reset

[nitrog42]

Hello, i'm fairly new to the forum but very happy using Gargoyle which fits perfectly my needs.
I have just a small issue, when settings port forward, applying the settings just reset everything on the page.
Example :
I set 7 or 8 port forward, apply it works.
I apply a port range forward, it works too.
But sometimes, if I add one port range (it happened only when setting port range), when pressing apply, what I got then is only 2 or 3 single port set, and everything else is removed.

I could probably add log but I'm not sure which one i should check ?

Thank your for your help and for this awesome router system !

[tapper]

Hi what router version do you have and what version of Gargoyle?

[nitrog42]

Hi, it's a TP-Link TL-WR1043N/ND v1 (1.7 on the case I think), and i'm using Gargoyle 1.7.0, but I already had this problem with Gargoyle 1.6.

[dlogictech]

Hello nitrog42,
May I suggest that you try a newer build of the firmware?
I seem to recall that I had an issue with losing configurations before.

I am using this version 1.7.X (Built 20150618-0226 git@fee548d)
which can be downloaded here:
http://www.gargoyle-router.com/phpbb/vi ... =14&t=7227

I specifically tested 12 port forwards for you on my router and it seems very stable and no loss of configuration, but keep in mind I am using a different model (D-Link DIR-835 rev. A1) router because it is the one currently acting as my gateway.

If need be I can indeed test the issue on my WR1043ND v1.6, but that may take some time to find a window of opportunity.

[nitrog42]

For now I updated to 1.72, I'll test in the future if I got the same problem, it might be fixed, if it isn't, I'll report it in this topic.
Thank you !