I'm brand-new to Gargoyle/OpenWRT, and would like to enable SNMP, so that I can view the status with software like PRTG.
Could this be added to the GUI?
Presuming that will take a while if it happens, can you provide guidance in enabling it manually?
Enable SNMP in GUI
Moderator: Moderators
-
DoesItMatter
- Moderator
- Posts: 1373
- Joined: Thu May 21, 2009 3:56 pm
Re: Enable SNMP in GUI
http://wiki.openwrt.org/doc/howto/snmp.server
You should be able to follow that and install via the command line.
Make sure you have an 8MB or larger flash
Also should have 32MB or larger of Ram
OpenWRT/Gargoyle have grown so much that
8MB Flash & 32MB Ram are now minimums for a router.
You should be able to follow that and install via the command line.
Make sure you have an 8MB or larger flash
Also should have 32MB or larger of Ram
OpenWRT/Gargoyle have grown so much that
8MB Flash & 32MB Ram are now minimums for a router.
Soylent Green Is People! 2x Asus RT-N16 = Asus 3.0.0.4.374.43 Merlin
2x Buffalo WZR-HP-G300NH V1 A0D0 = Gargoyle 1.9.x / LEDE 17.01.x
2x Engenius - ESR900 Stock 1.4.0 / OpenWRT Trunk 49400