How to force Minrtt even when class only uses low bandwidth

Report issues relating to bandwith monitoring, bandwidth quotas or QoS in this forum.

Moderator: Moderators

Post Reply
Javak
Posts: 1
Joined: Thu Apr 30, 2015 10:05 am

How to force Minrtt even when class only uses low bandwidth

Post by Javak »

Hello,

I found a thread from 2012 where pbix said that its possible to enable minrtt for connections that only use extremely low bandwidth.

My 'latency' class uses about 1kbps, which wont trigger minrtt even tho its listed under active connections and the link is at peak load.

I downloaded & successfully compiled the source code. What changes are required to qosmon that minrtt gets triggered independent of the actual bandwidth it uses?

Regards,
Javak

pbix
Developer
Posts: 1373
Joined: Fri Aug 21, 2009 5:09 pm

Re: How to force Minrtt even when class only uses low bandwi

Post by pbix »

qosmon is commented pretty well. Look at line 491.
Linksys WRT1900ACv2
Netgear WNDR3700v2
TP Link 1043ND v3
TP-Link TL-WDR3600 v1
Buffalo WZR-HP-G300NH2
WRT54G-TM

Post Reply