Yet another of these threads requesting help with OpenVpn.
I've looked at tens of thread on this forum and OpenWrt about how to enable OpenVpn as a client, but i am yet to succeed.
My progress so far is:
OpenVpn is running, but not connected.
1. I have downloaded a .opvn config file from a free Vpn server and have entered all details manually.
Result: Does not connect.
I have tested same .opvn config file on Android client and it connects immediately.
2. I have downloaded a .opvn config file from VPNGate and have entered all details manually.
Result: Does not connect.
Tested working on Android client.
Any help please.
OpenVpn Client VPNGate
Moderator: Moderators
OpenVpn Client VPNGate
WD MyNet N600 - Gargoyle 1.7.1
TP-Link Archer C5 - OpenWrt (community release)
TP-Link Archer C5 - OpenWrt (community release)
Re: OpenVpn Client VPNGate
What hardware and Gargoyle version are you using?
Can you help someone else get Gargoyle up and running?
TL-WDR3600 : Gargoyle 1.9.0 : NBN FixedWireless
TL-WR1043ND-V2 : Gargoyle 1.8.0 : 3G Huawei E160E
TL-WDR3600 : Gargoyle 1.9.0 : NBN FixedWireless
TL-WR1043ND-V2 : Gargoyle 1.8.0 : 3G Huawei E160E
Re: OpenVpn Client VPNGate
Thanks for replying.
I'm using the following:
WD MyNet N600 (better wifi coverage than my TP-Link Archer C5
)
Firmware is official Gargoyle 1.7.1
I also tried going back to 1.6.2 but still the same result.
I'm using the following:
WD MyNet N600 (better wifi coverage than my TP-Link Archer C5
)Firmware is official Gargoyle 1.7.1
I also tried going back to 1.6.2 but still the same result.
WD MyNet N600 - Gargoyle 1.7.1
TP-Link Archer C5 - OpenWrt (community release)
TP-Link Archer C5 - OpenWrt (community release)