I have a TPlink WR940n Ver1.4.I used Gargoyle Ver.1.6.2 good until lase week.
As Gargoyle 1.7.0 released, I had download and upgrade it by telnet mod(mtd -r write xxx.bin firmware)
Unfortunately,I had downloaded a wrong version...
(gargoyle_1.7.0-ar71xx-generic-tl-wr941nd-v2-squashfs-factory.bin)
Now,my router is bricked.
I try to use TTL mod,but I can't get the command line like youtube showing.[ ar7100> ]
https://www.youtube.com/watch?v=IHNrnLnLakE (12:10~12:20)
Any ideas?? please
Here is the log
U-Boot 1.1.4 (Jan 30 2012 - 18:27:20)
AP93 (ar7240) U-boot
DRAM:
sri
## TAP VALUE 1 = 7, 2 = 8
&j 5
▒read 0x100000ff
flash size 4194304, sector count = 64
Flash: 4 MB
hng default environment
▒ serial
Out: serial
Err: serial
▒▒ ag7240_enet_initialize...
No valid address in Flash. Using fixed address
▒▒▒ 0xf cfg2 0x7014
▒▒▒҂▒Һ2▒09:0b:ad
▒▒ up
No valid address in Flash. Using fixed address
: cfg1 0xf cfg2 0x7214
th1: 00:03:7f:09:0b:ad
ATHRS26: resetting s26
THRS26: s26 reset done
▒▒ up
eth0, eth1
Autobooting in 1 seconds
$▒▒ѥ▒▒▒image at 9f020000 ...
Uncompressing Kernel Image ...
Starting kernel ...
C▒▒
▒▒]▒сkernel loader for AR7XXX/AR9XXX
Copyright (C) 2011 Gabor Juhos <juhosg@openwrt.org>
Looking for OpenWrt image... found at 0xbf022000
Decompressing kernel... e!
▒▒ѥ▒▒▒kernel at 80060000...
▒r▒▒▒▒▒▒▒Linux version 3.10.49 (eric@Osiris) (gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.04 unknown) ) #1 Sun Jan 4 19:12:58 EST 2015
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU revision is: 00019374 (MIPS 24Kc)
[ 0.000000] SoC: Atheros AR7240 rev 2
[ 0.000000] Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:5.000MHz
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 02000000 @ 00000000 (usable)
.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x00000000-0x01ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x00000000-0x01ffffff]
▒r▒▒▒▒▒▒▒Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
@▒r▒▒▒▒▒▒▒Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
[ 0.000000] Kernel command line: board=TL-WR941ND console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd
[ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
[ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.000000] Writing ErrCtl register=00000000
[ 0.000000] Readback ErrCtl register=00000000
▒r▒▒▒▒▒▒▒Memory: 28720k/32768k available (2287k kernel code, 4048k reserved, 613k data, 232k init, 0k highmem)
[ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS:51
[ 0.000000] Calibrating delay loop... 05.42 BogoMIPS (lpj=1327104)
[ 0.080000] pid_max: default: 32768 minimum: 301
[ 0.080000] Mount-cache hash table entries: 512
0.090000] NET: Registered protocol family 16
▒r▒▒▒▒▒▒▒MIPS: machine is TP-LINK TL-WR941ND
▒r▒▒▒▒▒▒▒Kernel bug detected[#1]:
[ 0.300000] CPU: 0 PID: 1 Comm: swapper Not tainted 3.10.49 #1
[ 0.300000] task: 81828000 ti: 81826000 task.ti: 81826000
[ 0.300000] $ 0 : 00000000 00000061 00000000 802e0000
[ 0.300000] $ 4 : bfff1000 bf01fc00 00000000 80089fe0
[ 0.300000] $ 8 : 00000001 00000030 8180a000 ffffff80
[ 0.300000] $12 : 00000014 0000000e 00000007 00000001
[ 0.300000] $16 : bfff1000 bf01fc00 80390000 00000000
[ 0.300000] $20 : 00000023 80310000 8035eb4c 8033620c
[ 0.300000] $24 : 802feb90 8018da28
[ 0.300000] $28 : 81826000 81827e58 00000000 80338a18
[ 0.300000] Hi : 00000000
[ 0.300000] Lo : 11e1a300
[ 0.300000] epc : 8033bfc8 ath79_register_wmac+0x274/0x278
[ 0.300000] Not tainted
[ 0.300000] ra : 80338a18 ath79_setup+0x28/0x38
[ 0.300000] Status: 1000c003 KERNEL EXL IE
[ 0.300000] Cause : 10800024
[ 0.300000] PrId : 00019374 (MIPS 24Kc)
[ 0.300000] Modules linked in:
[ 0.300000] Process swapper (pid: 1, threadinfo=81826000, task=81828000, tls=00000000)
[ 0.300000] Stack : 00000000 80340d28 00000000 8032dc3c 00000000 803389f0 8035eb7c 80338a18
00000000 801cdd08 00000000 00000023 80310000 80113854 00000001 00000003
00000003 00000000 00000003 8035eb7c 8036cd44 803a0000 00000003 8035eb7c
8036cd48 803a0000 00000023 80336a78 0f0f0f0f 0f0f0f0f 0f0f0f0f 00000023
00000003 00000003 8033620c 0f0f0f0f 0f0f0f0f 0f0f0f0f 0f0f0f0f 80064bb8
...
[ 0.300000] Call Trace:
[ 0.300000] [<8033bfc8>] ath79_register_wmac+0x274/0x278
[ 0.300000] [<80338a18>] ath79_setup+0x28/0x38
[ 0.300000] [<80113854>] do_one_initcall+0xf0/0x198
[ 0.300000] [<80336a78>] kernel_init_freeable+0x150/0x208
[ 0.300000] [<80064bc8>] kernel_init+0x10/0x10c
[ 0.300000] [<80060878>] ret_from_kernel_thread+0x14/0x1c
[ 0.300000]
[ 0.300000]
Code: 24030001 080cefbc a0431015 <000c000d> 27bdffe8 00002021 afbf0014 0c0cef55 00002821
[ 0.310000] ---[ end trace bddda8c7a2df9117 ]---
[ 0.310000] Kernel panic - not syncing: Attempted to kill init! exitcode=0x0000000b
[ 0.310000]