WDS TL-WR1043ND V1(Gargoyle 1.5.11) with R024(no Gargoyle)?

[webipsum]

Hi, friends.

Objective:
WDS TL-WR1043ND V1 (Firmware: Gargoyle 1.5.11) vs Multilaser R024

Problem:
Primary Router: Conection OK (Local + Internet OK)
Secundary Router: Conection Limited (without local and Internet)

I think:
The Secondary Router scans the Primary Router in the WDS configuration. But does not connect the first router with it does not connect to the local network and the Internet.

See log of the Secondary Router:
1 2014-12-04 00:00:01 [SYS] System start
2 2014-12-04 00:00:02 [WLAN] STA(MAC Second Router) had associated successfully
3 2014-12-04 00:00:02 [WLAN] STA(MAC Second Router) set key done in WPA2/WPA2PSK
4 2014-12-04 00:00:47 [WLAN] STA(MAC Primary Router) had deauthenticated

Request:
Please. If anyone can help, thank you.

Information:
The following settings below.

= = = = = = = = = = = = = = = = =
Primary router (WAN + WIRELESS)
= = = = = = = = = = = = = = = = =

TL-WR1043ND V1
Firmware: Gargoyle 1.5.11
(gargoyle_1.5.11-ar71xx-generic-tl-wr1043nd-v1-squashfs-factory)

Local Network / LAN
Router IP: 192.168.1.1
Subnet Mask: 255.255.255.0
DNS Servers: Default DNS Servers Specified by ISP
[x] Allow NameCoin/OpenNIC Resolution
[ ] Force Clients To Use Router DNS Servers

Wireless

Wireless Mode: AP+WDS
Operation Mode: N+G+B
Channel Width: 20MHz
Transmit Power: Max 27 (0 - 27dBm)
Wireless MAC Filter: Disabled

Access Point SSID: NET01
Wireless Channel: 11
Encryption:WPA2 PSK
Password: 12345678
Broadcast SSID: Enabled
Wireless Client Isolation: Disabled

[x] LAN DHCP Server Enabled
DHCP range:
Start: 192.168.1.100
End: 192.168.1.249
Lease Time: 12 (hours)

= = = = = = = = = = = = = = = = =
Secondary Router (WDS Repeater)
= = = = = = = = = = = = = = = = =

Multilaser R024
Firmware: Original
Equivalent Tenda W268R

Basic Settings

[x] Enable Wireless

Network Mode: Mixed Mode 11b/g/n
SSID Main: NET02RPT
Network broadcast (SSID): [x] Enable [ ] Disable
BSSID: xx:xx:xx:xx:xx:xx (MAC NET02RPT)
Channel: 2462MHz (Channel 11)
Operating mode: [x] Mixed Mode [ ] Permission Course
Channel Broadband: [ ] 20 [x] 20/40
Guard Interval: [ ] long [x] Auto
MCS: Auto Selection
Concession Reverse Direction (CDI): [ ] Disable [x] Enable
Extension Channel: 2442 (Channel 7)
Aggregation MSDU (A-MSDU): [x] Disable [ ] Enable

Security Settings

SSID -- "NET02RPT"
Safe Mode: Mixed WPA/WPA2 - Personal
Algorithms WPA: [x] AES [ ] TKIP [ ] TKIP&AES
Password: 12345678
Range Renewal key: 3600 segundo

WDS Settings

WDS Mode: Repeater Mode
Encryption type: AES
Password: 12345678
AP Address MAC xx:xx:xx:xx:xx:xx (MAC NET01)
AP Address MAC
AP Address MAC
AP Address MAC

DHCP Server

DHCP [ ] Enable (Disable)
Start IP Address: 192.168.0.100
End IP Address: 192.168.0.200
Rental time: one day

LAN Settings

MAC Address: xx:xx:xx:xx:xx:xx (MAC NET02RPT)
IP Address: 192.168.1.2
Subnet Mask: 255.255.255.0

= = = = = = = = = = = = = = = = =

Thank you very much for your attention.

[webipsum]

Additional information:
The secondary router can not connect to the primary router.
In the log displays the following message:
4 2014-12-04 00:00:47 [WLAN] STA(xx.xx.xx.xx.xx.xx) had deauthenticated
Please, which means: had deauthenticated?
What is the appropriate configuration to the primary router to the secondary rotedor, able to either connect through WDS?
Thank you very much.