Report problems and success stories with Gargoyle on various hardware platforms.
Moderator: Moderators
croc
Posts: 3 Joined: Wed Jul 30, 2014 4:19 pm
Post
by croc Wed Jul 30, 2014 4:28 pm
Hi guyz,
I've try to install gargoyle 1.6.1 (gargoyle_1.6.1-ar71xx-generic-wrt160nl-squashfs-factory.bin) on my linksys 160NL (serial number CUR06)
three times it fails
. Power led flash and nothing happened. I can recoverer using tftp & core.bin official firmware.
For now i've successfully installed openwrt (attitude adjustment 12.09) but my goal is gargoyle qos…
any help?
thanks
Last edited by
croc on Tue Aug 05, 2014 8:24 am, edited 1 time in total.
n0pin
Posts: 129 Joined: Thu Jan 09, 2014 6:39 am
Post
by n0pin Wed Jul 30, 2014 5:31 pm
You should try upgrading from OpenWRT to Gargoyle using sysupgrade image. Do not try to preserve settings.
tapper
Moderator
Posts: 1076 Joined: Sun Oct 13, 2013 5:49 pmLocation: Stoke-on-trent UK
Post
by tapper Wed Jul 30, 2014 6:09 pm
Hi i have the 160nl and i upgraded from ddwrt. If flashing from openwrt dont work then give flashing from ddwrt a shot.
Linksys WRT3200ACM
croc
Posts: 3 Joined: Wed Jul 30, 2014 4:19 pm
Post
by croc Thu Jul 31, 2014 2:08 am
May i should try gargoyle 1.5.10 (based on released openwork AA) or install from packages like
http://www.gargoyle-router.com/phpbb/vi ... f=8&t=5453 (eric post)
which 160nl serial number do you have ? CUR01 or CUR06 ?
Last edited by
croc on Tue Aug 05, 2014 1:57 am, edited 4 times in total.
croc
Posts: 3 Joined: Wed Jul 30, 2014 4:19 pm
Post
by croc Mon Aug 04, 2014 5:31 pm
i confirm it works.
Last edited by
croc on Tue Aug 05, 2014 1:58 am, edited 3 times in total.
Dunedain
Posts: 1 Joined: Mon Oct 20, 2014 4:47 pm
Post
by Dunedain Mon Oct 20, 2014 4:53 pm
Hi everyone, I'm using OpenWRT at the time, but i have a e2100l. I need to know if the FW for wrt160nl work fine with this other router, or if i need other FW to migrate.
. Power led flash and nothing happened. I can recoverer using tftp & core.bin official firmware.