Hi,
I just installed Gargoyle firmware on my TP-Link 1043ND and I'm please how it works. Seems to be better than DD-WRT firmware but i have one problem. I want to set it up as a client for strongvpn. After some trial an errors I managed to make to connect but the traffic is not redirected through it. Maybe I'm missing some settings. If anyone has any ideas it would be much appreciated. Bellow are the settings i use:
remote 98.158.115.227 443 tcp
remote 98.158.115.227 3690 tcp
remote 98.158.115.227 2401 tcp
remote 98.158.115.227 8443 tcp
key-direction 1
cipher none
auth none
no-iv
client
dev tun
resolv-retry infinite
nobind
persist-key
persist-tun
;http-proxy-retry
;http-proxy 98.158.115.227 80
verb 4
reneg-sec 86400
echo vpn-in2 ovpn226
tun-mtu 1500
route-method exe
route-delay 2
redirect-gateway def1
comp-lzo no
hand-window 30
ca /etc/openvpn/grouter_client_qmyslayhxhoz_ca.crt
cert /etc/openvpn/grouter_client_qmyslayhxhoz.crt
key /etc/openvpn/grouter_client_qmyslayhxhoz.key
tls-auth /etc/openvpn/grouter_client_qmyslayhxhoz_ta.key 1