I'm running a 1043ND as a main router and two 841Ns as wireless bridges/access points. I'd like to restrict all three to the 2.5GHz Wireless N frequency only, and set up a WAP54G I have as an access point for my Wireless G clients.
Is there is a a way to get the three TP Link devices to be N only in the 2.5GHz spectrum?
Any advice?
[NG]Owner
Setting Router to N Only?
Moderator: Moderators
- DoesItMatter
- Moderator
- Posts: 1373
- Joined: Thu May 21, 2009 3:56 pm
Re: Setting Router to N Only?
Just choose the N+G+B setting
The router will always default to the highest connection speed possible
based on its signal strength.
As long as NO OTHER wireless-G clients try to connect to your
Wireless-N WPA2-AES network - it will stay in Wireless-N mode
Once a wireless-G client connects to it, it will drop down to
wireless-G speeds
So just don't configure any clients to use the Wireless-N network
if they are only capable of wireless-G speeds.
The router will always default to the highest connection speed possible
based on its signal strength.
As long as NO OTHER wireless-G clients try to connect to your
Wireless-N WPA2-AES network - it will stay in Wireless-N mode
Once a wireless-G client connects to it, it will drop down to
wireless-G speeds
So just don't configure any clients to use the Wireless-N network
if they are only capable of wireless-G speeds.
Soylent Green Is People!
2x Asus RT-N16 = Asus 3.0.0.4.374.43 Merlin
2x Buffalo WZR-HP-G300NH V1 A0D0 = Gargoyle 1.9.x / LEDE 17.01.x
2x Engenius - ESR900 Stock 1.4.0 / OpenWRT Trunk 49400
2x Asus RT-N16 = Asus 3.0.0.4.374.43 Merlin
2x Buffalo WZR-HP-G300NH V1 A0D0 = Gargoyle 1.9.x / LEDE 17.01.x
2x Engenius - ESR900 Stock 1.4.0 / OpenWRT Trunk 49400