Problem with TP-Link WR1043ND

Report problems and success stories with Gargoyle on various hardware platforms.

Moderator: Moderators

Post Reply
Grendel99
Posts: 30
Joined: Sun Jul 17, 2011 1:40 am

Problem with TP-Link WR1043ND

Post by Grendel99 »

Hi All,
I have a TP-Link WR1043ND router and a D-Link modem. I had to turn them both off to refresh the connection, now when I turn them back on I am unable to connect to the internet through the router. I'm not sure what has happened, I didn't think simply turning them on and off would cause this problem. I believe the problem is with the router, I can still access the Gargoyle Management Utility, but nothing else. If anyone has any suggestions I would greatly appreciate it as I don't know what to do now.
Thank you

pbix
Developer
Posts: 1373
Joined: Fri Aug 21, 2009 5:09 pm

Re: Problem with TP-Link WR1043ND

Post by pbix »

It sounds like you turned off the router because your internet was not working. Now after the router reboot the internet is still not working.

Perhaps the problem is not in your router.

I would investigate the web page of your modem and see what information you can see there.
Linksys WRT1900ACv2
Netgear WNDR3700v2
TP Link 1043ND v3
TP-Link TL-WDR3600 v1
Buffalo WZR-HP-G300NH2
WRT54G-TM

Grendel99
Posts: 30
Joined: Sun Jul 17, 2011 1:40 am

Re: Problem with TP-Link WR1043ND

Post by Grendel99 »

Hi, the modem is working ok. My PC and other mobile devices are detecting the network, but they can't access the internet, also the signal is not constant, it drops out sometimes. I had this exact same problem before, at that time I thought the router must have been broken so I replaced it, now it has happened again, surely turning it off can't cause this to happen twice!

Post Reply