cannot login Gargoyle Dlink DIR-601

[tinhtu]

I have Linksys wrt54gl as router with LAN IP 192.168.1.1
recently I flashed my Dlink Dir-601 with Gargoyle to set as client bridge. I did not change the LAN IP so it must be 192.168.1.1. Now I try to login 192.168.1.1 it always goes to Linksys router. I tried to hit the seset button of the Dlink, it did not work. Tried 30/30/30 did not work. Tried telnet 192.168.1.1 did not response. Try Fonflash to flash to DD-WRT did not work.

I just want to log in my Dlink client bridge to change Gargoyle setting. Please help.

[DoesItMatter]

You will have to connect a computer directly to the one of the LAN
ports on your DIR-601 to access the Gargoyle GUI

When you do this - make sure nothing is plugged into the WAN port
of the Gargoyle GUI so that it doesn't get anything from 192.168.1.x

Make any configuration changes like this, then you can disconnect
the computer from the DIR-601

[tinhtu]

You will have to connect a computer directly to the one of the LAN
ports on your DIR-601 to access the Gargoyle GUI

I did that

When you do this - make sure nothing is plugged into the WAN port
of the Gargoyle GUI so that it doesn't get anything from 192.168.1.x

I set up as wireless bridge. So it should not have anything connect to WAN

I saw you have the Dlink 601 in your signature. Did you set up this:
http://www.gargoyle-router.com/wiki/lib ... bridge.jpg

Thank you

[tinhtu]

I found solution for my problem:

Reinstall the Gargoyle firmware using this tutorial
http://wiki.openwrt.org/toh/d-link/dir-600#installation

I set for Bridge IP 192.168.1.20
Subnet Mask 255.255.255.0
AP/Gateway IP 192.168.1.1 (This is form my router)

Right now I can login to my Gargoyle Dlink 601 via 192.168.1.20

Hope this can help someone.

[hnl_dk]

In case you have nod32, please try to disable it, before trying to visit the website.

[ispyisail]

failsafe may have been another option

http://wiki.openwrt.org/doc/howto/generic.failsafe

[Nreokfkorer]

Very good and informative exchange .. Thank you!