Gargoyle Forum

In your Gargoyle git folder, run the following git fetch --all git pull This assumes you are already on the base_on_openwrt_1907 branch. Then make clean make FULL_BUILD=true <your target> That error usually just requires you to restart the firewall, which can be triggered by saving your connection s...

I haven't documented how this plugin works yet and i do apologise. https://scontent.fsyd7-1.fna.fbcdn.net/v/t1.0-9/82405342_10157770086144344_3509044068162207744_o.jpg?_nc_cat=103&_nc_ohc=El-2V1RfDBcAQnL43wyJApj241DPoZ1pzJLZ0kzgumQDsIr8gOZDt5Tbw&_nc_ht=scontent.fsyd7-1.fna&oh=869cb5a9fab...

I'm surprised it is pre-installed, but no big deal. Don't edit the config file by WinSCP, at least not until you are familiar with how the config file should be laid out. There's entire sections missing from the base config (i.e. it doesn't do anything) until you configure it correctly. When configu...

You'll need to install on that one.
The easiest check is probably the presence of /etc/config/gargoyle_stamgr If you're already on WinSCP, but the plugin manager in the GUI is easier visually.

Gcc should remain at 7.5.0, you may need to make clean to fix the build environment. And make sure you have the latest code. The target config sets the gcc version (as you're aware above) This commit (https://git.openwrt.org/?p=openwrt/openwrt.git;a=blobdiff;f=toolchain/gcc/common.mk;h=f7390c159ec9a...

Is there a logread with it? I don't see one.

Yes the STA Manager plugin is available as part of 1.12.0. It might already be installed depending on which device. Otherwise installing via the plugin manager as usual. I hope the interface is self explanatory, but if you need help just ask. It runs on about a 30 second resolution, so in your scena...

Correct. Don't preserve settings or restore a backup.

Yes, you can bring the old /etc/hosts and /etc/ethers files. No, you can't restore or preserve settings, as per the countless warnings.

Hi,

jvain2005 wrote:Any idea if WR841N is going to be supported for 1.12?

No, it does not have sufficient flash memory.
OpenWrt are also dropping official support for these after the next release (this week).

jvain2005 wrote:Can I use WR842 firmware on WR841N ?

No, they are not at all similar