Gargoyle Forum

hi yes i read it and tpl is the first command i use after power up. othewise i couldnt even run other commands... TFTP from server 192.168.1.169; our IP address is 192.168.1.10 Filename 'boot.bin'. Load address: 0xa800000 Loading: T T T T T T T T T T Retry count exceeded; starting again i have no co...

Hi
Serial connection is ok.
But for tftp i need IP connectivity between router and pc
But i cant ping router and when router tries to acess tftp server, it fails
Modem is 192.168.1.10
PC is 192.168.1.169
This is The configuration from printenv

Lantis wrote:Is port 69 open on the computer that is acting as a server

yes, i can tftp from my pc to my pc (tftp on himself)
port is layer4 in osi model
ping, which is layer3, is not working

hi
i connected through serial (failsafe not working) and tried to flash via tftp, but by pc can't reach the router
i run printenv on router to check the ip
router ip: 192.168.1.10
server ip (my pc): 192.168.1.169
active eth: eth0
i don't have layer3 connectivity between router and pc

i can't failsafe
sys led is on for two seconds after power up and then it shuts down and only pwr led stays on (tried pressing qss / reset button, sys led still not blinking)

hello, few days ago i tried to flash a gargoyle or openwrt firmware, but something went wrong and my router is bricked. i connected through serial and tried to flash via tftp, but by pc can't reach the router i run printenv on router to check the ip router ip: 192.168.1.10 server ip (my pc): 192.168...