Gargoyle Forum

You SHOULD be able to flash from Gargoyle/OpenWRT -> DD-WRT via the Gargoyle GUI, but I would recommend doing a reset to defaults first, only set a password, then go ahead and flash this version from the Gargoyle GUI http://www.dd-wrt.com/dd-wrtv2/downloads/others/eko/BrainSlayer-V24-preSP2/2013/02...

Hi, I have been using Gargoyle for some time now on my WZR-HP-G300NH2, but would like to revert to the Buffalo DD-WRT firmware. I did find the thread that DoesItMatter created for the WZR-HP-G300NH, but the instructions provided there are for the stock DD-WRT firmware and require some hex-editing. A...

Hi, I'm running v1.5.8 on a Buffalo WZR-HP-G300NH2. I'd like to point my PC's to the router for synchronizing time. However, I can't get my Windows PC to connect to the the NTP service on the router. I've checked with netstat that the service is running on the router but when I go into my Windows ti...

Posting an update for the search engines. After connecting to the DLink Web UI, I noticed that it's WAN IP was showing as 0.0.0.0, which was odd since the WAN IP should be the reserved IP in Gargoyle. I eventually realized that my DHCP range was set to go upto 192.168.0.150 and Gargoyle was not hand...

Posted in the troubleshooting forum first, but figured I'd update here as well to make up :) Successfully upgraded my Buffalo WZR-HP-G300NH2 from DD-WRT (Buffalo build) to Gargoyle 1.5.8. I logged in via telnet and then applied the squashes-says upgrade.bin file as per the OpenWRT wiki. So far no is...

I recently upgraded my Buffalo WZR-HP-G300NH2 from DD-WRT (Buffalo build) to Gargoyle 1.5.8. I also have a DLink DIR-825 running DD-WRT. The DLink acts as a router for a separate subnet (192.168.1.x) than the Buffalo which is the primary router for the 192.168.0.x subnet. The Dlink has a WAN IP of 1...