Gargoyle Forum

yes youre right, very nice link you posted. Thank you. Now i can't wait to flash ...... and than with my "lucky strain" depressed when the third router is gone :evil: hahaa was just a joke :o Can I ask you at the end some questions !? - Is it possible to use 23.05.2 ( Or simillar ) repo fr...

I got an Linksys WRT1200AC v1.
Can you say if it's save to build the master branch for mvebu or should i build with .
Does the upgrade make sense or is it just OpenWRT upgraded ?

thank you

Ah ok. I am nearly to give up. I did everything what the HowTo's say but get no output from the port. I installed directly the manufacturer drivers and the port changed from /dev/ttyUSB0 to /dev/ttyCH341USB0 but no output. I tried now putty, tio and screen /dev/ttyCH341USB0 11520 for example. setser...

As far as i know yet its not the COM Port its /dev/ttyUSB0 with this chip. But any of my attemts with putty for linux and mediacom (!?) with set baudrate (11520) Data Bit and so on shows blank screen no output at all. Maybe its the pin contact. Maybe wrong Volt setting: 3 Jumpers in the middle isnt ...

Hello, i've got that serial adapter with jumper for 5V and 3.3V: https://www.ebay.de/itm/144123804777?mkcid=16&mkevt=1&mkrid=707-127634-2357-0&ssspo=tg9hdLAtSmS&sssrc=4429486&ssuid=CCInOX_kQ6K&var=443797148874&widget_ver=artemis&media=COPY the pins seems to fit And us...

Hello, can you say if this cable the right one !? DEWIN USB-zu-TTL-Konverter, PL2303HX RS232-Upgrade-Konverter USB-zu-COM/TTL-Seriell-Adapter STC-Downloadkabel https://amzn.eu/d/coBOZXn Because you say i need 3,3V cable but in the HowTo's i found there stands i dont have to plug that "power&quo...

Ok thank you for your guidance ! I will try it ....

You asked what was buggy on 1.15 that was that often stands in the GUI "undefined" for example when i reboot in the field that appears there just stands "undefined".

No 1.14 !? Then make it a sense that i have make/build bulls**t. What does not make sense that i can't switch to an bootable partition ( the device has two ). So i must open the router and connect serial to usb :( Can you give me some advises in the right direction how to make it ? I mean which Prog...

Hello, first i have to say sorry for my english. I tested Gargoyle 1.13 on my LinksysWRT 1900acs v2 and found it to be very good for my needs. But than i got stupid and build the version 1.15 and flashed it. The firmware was buggy so i decided to give 1.14 a try than build it and flashed it. So i di...