setup_a_wireless_repeater
This is an old revision of the document!
Setup a wireless repeater via Cable
Introduction
Setup a wireless repeater, though using an Ethernet wired link from the LAN of the main router to the repeater router.
Note: You won’t get any of the Gargoyle smarts with this configuration as it is just a “dumb switch”
Configure
Set “Connect Via” to Disabled
Bridge WAN to LAN. Setup AP as required.
setup_a_wireless_repeater.1507525158.txt.gz · Last modified: 2017/10/09 04:59 by ispyisail
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
