This is an old revision of the document!


A PCRE internal error occured. This might be caused by a faulty plugin

==== Scenario ==== You have an existing ISP supplied Router/Modem which is already set-up to provide an Internet Connection to the household LAN. Unfortunately, You cannot load Gargoyle directly onto the existing Router/Modem. You want to introduce a Gargoyle Router because it is awesome. ==== Objective ==== Introduce a new Gargoyle Router into an existing Household network. ==== Approach ==== Going forward, the most simple setup will see the Gargoyle router doing pretty much everything and the existing ISP supplied Router/Modem demoted to simple modem duties. ==== Prepare a Gargoyle Router ==== [[supported_routers_-_tested_routers | Select a new Router]], and [[install | install Gargoyle]]. ==== Reconfigure existing Modem/Router ==== To Bridge or not to Bridge, that is the question! If you are configuring an __ADSL__ modem then it is preferable (if possible) to put the modem in**to bridge** mode; which in effect, will connect Gargoyle directly to your ISP. Otherwise, if you can**not bridge**, then set the Modem LAN IP Address to **192.168.0.1** to form one node on a very simple network segment just between the Modem and the Gargoyle router (see below). Another network segment will connect all of your devices with IP addresses like 192.168.1.XXX ==== Physical Connections ==== Connect the Modem LAN port to the Gargoyle WAN port. ==== Configure Gargoyle ==== == Gargoyle - Connection - Basic == ^ To Bridge ^^ or ^ not to Bridge ^^ ^ Internet / WAN ^| ^ Internet / WAN ^^ | Connect Via: | PPPoE (Wired) | | Connect Via: | Static IP (Wired) | | User Name: | from ISP | | Static IP: | **192.168.0.2** | | Password: | from ISP | | Subnet Mask: | 255.255.255.0 | | Reconnect Mode: | Keep Alive | | Gateway : | **192.168.0.1** | ^ Local Network / LAN^^ | Router IP: | 192.168.1.1 | |Subnet Mask: | 255.255.255.0 | | DNS Servers: | Default DNS Servers Specified by ISP | == Gargoyle - Connection - DHCP == ^ DHCP^^ | ☑ LAN DHCP Server Enabled || | DHCP range: \\ Start: \\ End: | \\ 192.168.1.100 \\ 192.168.1.249 | | Lease Time: | 2 hours | From here you can [[gargoyle_setup | configure]] other features or [[common_scenarios|scenarios]] as required.

scenario-modem.1430727930.txt.gz · Last modified: 2015/05/04 08:25 by nworbnhoj
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki